Site Search Results

Yes, you can mix similar products together at any ratio to make more color options.

You can also mix with 10% General Finishes Liquid Oil Based Wood Penetrating Stains to obtain a slightly thinner stain than the normal Gel Stain formula.

Yes, there are a couple of ways. Dye Stain Reducer is the clear base that we use when manufacturing General Finishes Dye Stains. The Reducer is made first, then the dye color is added.

It is easy to make your own custom color Dye Stain by adding in 10% increments of Dye Stain color to Reducer until you achieve the color you want. It is not possible to mix too much of our Dye Stain and Reducer together.

Q: Which 12 colors will remain in the Milk Paint line?

Yes, one of its uses is to dilute dye stain colors. Dye Stain reducer is the clear base the we use when manufacturing our dye stains. We make the reducer first, then add the dye color.

It is easy to make your own custom color Dye Stain by adding in 10% increments until you achieve the color you want. It is not possible to mix too much of our dye stain or reducer together.

Additionally, General Finishes Water Based Stains can be mixed into the reducer, which will lighten the color and thin the viscosity so it will penetrate deeper into the wood.

It's always possible to darken a stained surface, but you cannot lighten a stained surface after the finish has dried.

When the surface is still wet, you can try to lighten the color by scrubbing with mineral spirits. If the finish has hardened, you will need to sand down your current stain and start over or use one of our paints.

You can mix GF Gel Stain colors to create a custom color.

You can also thin Gel Stain with 10-15% mineral spirits.

Always test our color on a hidden area of your project before beginning.

It is normal to see a bit of stain on the brush when applying the first coat of topcoat. Topcoats often pull a bit of color on the first pass, but good preparation will minimize this.

To prepare open grains woods such as raw Oak for a water-based stain, we recommend sanding with 180-grit followed by no more than 220-grit sandpaper.

The word "latex" is often a misnomer and is used everywhere to differentiate a water-based product from an oil-based product. The same as the word “Kleenex” is used to describe any type of facial tissue, regardless of the brand.

Today, "latex" is the technical term for a suspension (U.S.) or emulsion (European) of microparticles in water.

Putty comes in two forms, pre-colored or as a stainable wood filler designed to fill minor imperfection such as nail holes, cracks, and gouges in the wood surface. Putty will display stain a bit differently than wood, so it is not a "perfect" fix, but a good one.

The goal is to get the best possible color match to either the color of the raw wood or the color of your existing finish.