Site Search Results

We know of many customers that have achieved great results from buffing Arm-R-Seal with auto polishes, providing that the finish has cured for 7 to 10 days.

As with all products that are not manufactured by General Finishes, always test for compatibility on a hidden area of your project before getting started.  

There are several techniques by Jeff Jewitt of Homestead Finishing Products:

DRY BUFF WITH MIRKA ROYAL MICRO PAPER

Using Mirka Royal Micro sandpaper, always start with 1500-grit sandpaper. Begin with a small area, make 2-3 passes, then evaluate results. Go to a heavier grit if surface irregularities are not fully removed. Finish with 1500-grit paper.

After your finish has cured, the best way to clean is with a water-damp rag. If your surface requires deep cleaning due to grease or grime build-up, add a speck of a strong dish detergent, such as Dawn or a bit of vinegar to your damp rag.

If need deeper cleaning, use General Finishes Orange Oil Polish.

You can lightly buff with 0000 steel wool and General Finishes Orange Oil Furniture Polish - nothing too aggressive.

Wood Turner's Finish does not need wet sanding. If feel the need for more sheen, dry polish with Merka Abralon 1500-4000 grit or Micro Mesh 4000-8000.

"Cure time" is the amount of time needed for the finish on a piece to reach maximum hardness and be ready for normal use. This is different than "dry time." 

Water-based finishes cure faster than oil-based finishes, approximately 21 days vs 30 days under ideal conditions (70°F and 50% humidity).

Even though there is internet chatter about removing wax with 3rd party products, mineral spirits or vinegar, none guarantee success.

There is an old saying in the industry. "Once you wax, you cannot go back". Nothing adheres well to wax and even after cleaning, the wood grain can become contaminated. Wax can penetrate the wood, making future paint or stain finishes or touch-ups difficult or impossible.